Clean debris from from the surface with a clean, damp rag. The surface should be completely dry before proceeding with applying the tape.
Without over-stretching the tape, apply the adhesive side to the surface.
Use a weighted roller to ensure the bond from the tape to the surface and cut as needed, leaving a minimal gap. Make sure not to stretch the glazing tape around corners which can result in thinning on the outside and may create a bulge on the inside. Avoid overlapping the foam tape as it will not compress enough to avoid gaps.
For small gaps, use a silicone or other sealant that will work with the JVCC DC-WGT-01 Window Glazing Tape product.
Pull back a short length of the liner to create a tab.
Center and install glass
Remove the liner by the tabs and press the glass into the foam tape.
Allow 24 to 72 hours for full adhesion strength.
Make sure to store tape at room temperature and apply on a not-cold surface.